Leave a Message
We will call you back soon!
Your message must be between 20-3,000 characters!
Please check your E-mail!
More information facilitates better communication.
Submitted successfully!
We will call you back soon!
Leave a Message
We will call you back soon!
Your message must be between 20-3,000 characters!
Please check your E-mail!
—— Peter
—— Vinay
—— Alvin
—— Cameron
Tighten the set-screw in the cone.
Clean the contact surface on both sides, transducer-cone and horn. Apply a drop of machine oil on both sides. Screw the horn onto the transducer-cone and tighten it with the provided tools.
Set-up and adjusting of the feed-tray (The water thank is not supplied)
Position the feed-tray with a proper inclination. Adjust the water-dripping device to feed a mixture of abrasive and water to the tool. A piece of vinyl hose, attached to the end of the feed-tray, is used to feed the grit and water uniformly to the work piece along the horn and drilling tool. The abrasive grit is composed of carborundum (SiC) and can be re-used.