The rear partition of the automobile is generally applied to two kinds of processes: one is the hot-melt riveting point welding of the automobile rear partition plastic column, and the other is the ultrasonic puncture welding of the plastic rear part of the automobile rear partition. The position of the different rear partitions of the automobile needs to be welded, after the automobile The separator welding opportunity is applied to the ultrasonic or hot riveting process.
Automobile rear partition hot-melt riveting point welding machine
Riveting the plastic column and holding the rear partition of the car
Automobile rear baffle hot-melt riveting spot welding picture
The multi-head hot rivet welding process can be used to form the rear pillar plastic column of the automobile.
Such a car interior parts hot-melt riveting point, smooth surface
Automobile rear partition plastic pendant ultrasonic welding machine
Generally, the plastic buckle of the automobile rear bulkhead is using ultrasonic puncture welding, and the hot-melt welding can also be used for the rear partition of the automobile with good weldability.
The rear partition of the car is distributed at various positions, suitable for ultrasonic welding, and the ultrasonic angle can be switched.
Automotive rear bulkhead plastic pendant ultrasonic welding machine introduction:
1. Simultaneous welding with multi-head ultrasonic system (domestic or imported system)
To sum up:
The car rear partitions of each auto supplier are different, and the most suitable process is adopted according to the specific product.
Contact Person: Ms. Hogo Lv
Tel: 0086-15158107730
Fax: 86-571-88635972