Ultrasonic atomizers use electronic high-frequency oscillations to cause the high-frequency resonance of the ceramic atomizer to generate ultrasonic waves. Cavitation occurs when ultrasonic waves propagate in water. The atomizer uses the explosion of a cavity between water and air to pulverize the water around the cavity into 1-3μm particles, so water mist is generated on the water surface. This method does not require heating or adding any chemical reagents. Compared with ultrasonic atomization and heating atomization, energy can be saved by 90%.
In addition, a large amount of negative ions will be released during the atomization process to purify the air and promote the respiration of plants. The nutrients in the nutrient solution can be suspended in space for more than two hours.
Under the correct usage, the service life of the atomizer is about 3000 hours, and it is easy to replace. The service life is also related to the quality of the water. If scale deposits on the atomization sheet, it must be cleaned with a soft cloth. According to different water quality and purpose of use, different atomization films can be used. For example, stainless steel-clad atomization films are used in areas with hard water quality, and glass-glazed atomization films are used in environments that require acid resistance. The hardness of ultrasonic nutrient solution is much higher than that of clean water and tap water, so stainless steel-clad atomized sheet is used. When using the ultrasonic atomization of electric function water for space disinfection and sterilization, use corrosion-resistant glass glaze and other atomization sheets. There are also many styles of atomized film such as titanium plated, ceramic silver plate, stainless steel plate and nickel plated.
When the atomizer is normal, the power is turned on, and the power atomizer on the surface of the atomizer only sprays water and does not spray or the amount of mist is reduced. The reasons are as follows:
1. The water quality has deteriorated.
2. The oil and other ingredients in the water cause excessive surface tension of the water.
3. Excessive scale deposits on the surface of the transducer.
4. The atomized transducer chip has expired and failed.
5. The water level is too high, exceeding the best atomized liquid level range
Contact Person: Ms. Hogo Lv